Como Programar Descalcificador Cillit Data ^hot^ Online

volatile unsigned int pulse_count = 0; void hall_sensor_ISR() // Interrupt on each magnet pulse pulse_count++; if (pulse_count >= PULSES_PER_LITER) // e.g., 450 pulses/L total_flow_m3 += 0.001; // add 1 liter pulse_count = 0;

// Step 5: Refill brine tank move_valve_to(BRINE_REFILL); delay_minutes(12); // depending on salt amount needed

// Step 3: Slow rinse (displace brine) move_valve_to(SLOW_RINSE); delay_minutes(15); como programar descalcificador cillit data

// Step 4: Fast rinse (final cleaning) move_valve_to(FAST_RINSE); delay_minutes(8);

void save_installer_settings() eeprom_write(ADDR_HARDNESS, new_hardness); eeprom_write(ADDR_PERSONS, new_persons); // Recalculate capacity_total based on persons and hardness capacity_total = new_persons * 70 * new_hardness; // 70L/person/day estimate volatile unsigned int pulse_count = 0

// Step 6: Return to service move_valve_to(SERVICE);

| Menu | Parameter | Range | Default | |-------|-----------|-------|---------| | P01 | Water hardness (°dH) | 5 - 40 | 20 | | P02 | Number of persons | 1 - 10 | 4 | | P03 | Regeneration interval (days max) | 1 - 30 | 7 | | P04 | Regeneration time (hour) | 0 - 23 | 2 | | P05 | Salt type (NaCl / KCl) | 0/1 | 0 | | P06 | Flow meter unit (pulses/L) | 100 - 1000 | 450 | if (pulse_count &gt

void check_faults() if (flow_rate_lpm > 0 && hall_sensor_pulses == 0) display_error("E1 – Flow meter stuck"); if (brine_tank_empty_sensor == HIGH) display_error("E2 – Salt low"); trigger_led_flash(RED); if (motor_current > 1.5A) display_error("E3 – Valve jammed"); stop_motor();